Hello Jude-Community,
i have some problems with a component diagramm.
I try to connect one "provided Interface" (pi) of a compenent with a "required interface" (ri) of an other component. Every time i move the ri over the pi, i get an error-message:
"Different Interfaces cannot be combined. Please combine a provided interface and a required interface with the same model."
If i try to put the two interface very close together, i have the ptobleme that both interfaces need a name, but i only need one name.
Is there any suggest?
Thanks
Hendrik

P.S. sorry for my poor english, i'm not a native speaker