To illustrate what I'm saying. Supose I have this 2 classes:





Then I build the following sequence diagram (Interaction1):





Notice in the figure above that when the message identified by the doSomething1() operation is selected, a list of operrations available apears in the drop down list in the properties window on the left pane. I'm supposed to see all the methods built in AnyClass1 in that drop down list, because the lifeline x is based on AnyClass1.


Now, let me build another sequence diagram (Interaction2) with an InteractionUse referencing the sequence diagram above (Interaction1) and send the message doOperation1() to it:





When I select the message identified by the Message6() operation in the diagram, to change it for one of the methods in the drop down list (in the properties window), none of the methods belonging to AnyClass1 is shown:





So... why don't I get the doSomething1() in the drop down list? I expected Jude to show me at least the methods I used as operations in gate messages inside Interaction1. Or all of the methods of the classes attached to the lifelines belonging to Interaction1. Am I thinking wrong?